Removing And Installing Lower Transverse Link - Seat Leon 2013 Workshop Manual

♦ Torque wrench - V.A.G 1332-
Removing
– Loosen wheel bolts.
– Raise vehicle.
– Remove wheel.
– Remove spring ⇒ page 215
– Unhook line -1- from retainer -2- -arrows-.
– Unscrew nut -3-, and remove washer -4-.
– Unscrew bolt -5-.
– Use felt-tip pen or similar to mark position of eccentric bolt
-3- in relation to subframe.
– Unscrew nut -2- and pull out eccentric bolt -3-.
– Take out upper suspension link -1-.
Installing
Installation is carried out in reverse order, noting the following:
• The threaded connections of the suspension link may only be
loosened and tightened in the unladen weight position
⇒ page 8 .
Specified torques
♦ ⇒ "5.1 Assembly overview - transverse links", page 195
– Check wheel alignment
5.4 Removing and installing lower trans‐
verse link
Special tools and workshop equipment required
.
⇒ page 302 .
León 2013 ➤ , León ST 2013 ➤
Running gear, axles, steering - Edition 06.2018
5. Suspension link, track rod
201