Pressing out bonded rubber bush
– Press out bonded rubber bush as shown.
1 -
Press tool - VW 411-
2 -
Assembly tool - 3348-
3 -
Wishbone
4 -
Tube for wheel bearing - 3345-
5 -
Tightening plate - VW 401-
Installation position of bonded rubber bushes
•
The embossed arrow points between the two markings
-arrows A- in the wishbone.
•
Lever -arrow B- must face centre of vehicle.
Insert the bonded rubber bush
– Press in bonded rubber bush as illustrated.
1 -
Press tool - VW 412-
2 -
Sleeve - VW 459/2- , inner shoulder of sleeve -arrow- faces
downwards
3 -
Wishbone
4 -
Tube for wheel bearing - 3345-
5 -
Tightening plate - VW 401-
Note
Press in bonded rubber bush until wheel bearing tube - 3345-
makes contact with wishbone.
León 2013 ➤ , León ST 2013 ➤
Running gear, axles, steering - Edition 06.2018
4. Lower suspension link, swivel joint
85