Seat Leon 2013 Workshop Manual page 343

– Bounce springs.
– Measure standing height at all four wheels and note it.
Note
Setting device - VAS 6430- is not allowed to be moved on
♦
alignment beam.
For the next step the wheel alignment platform must be set at
♦
the lowest available position.
– Turn setting device - VAS 6430- upwards so that alignment
beam is parallel to middle of measurement transducers on
front wheels, in order to perform a correct measurement with
distance measuring unit -1-.
1 - Distance measuring unit with tape measure and socket pin
– Position setting device - VAS 6430- at distance -a- of 1500 mm
± 25 mm from centre point of hub of front wheels to beam of
setting device - VAS 6430- .
Caution
♦ Distance -a- of 1,500 mm ± 25 must be measured on both
sides of vehicle and setting device - VAS 6430- must then
be aligned.
♦ Distance -a- must be same on both sides of car.
– Mount measurement transducer -1- of front wheels onto set‐
ting device - VAS 6430- .
– Measure height value -a- between standing surface of setting
device - VAS 6430- and wheel support surface on wheel align‐
ment platform. Enter value in wheel alignment computer.
León 2013 ➤ , León ST 2013 ➤
Running gear, axles, steering - Edition 06.2018
4. Front camera for driver assist systems
337