Seat Leon 2013 Workshop Manual page 156

León 2013 ➤ , León ST 2013 ➤
Running gear, axles, steering - Edition 06.2018
– Remove right and left brake calipers and hang on the body
with wire ⇒ Brake system; Rep. gr. 46 ; Rear brake; Assembly
overview - rear brake .
Vehicles with electrical parking brake
– Unclip electrical wire -1- from bracket -2- on axle beam (both
sides) -arrows-.
Vehicles with manual parking brake
– Remove right and left brake cable ⇒ Brake system; Rep. gr.
46 ; Parking brake; Brake cable: removal and installation .
Vehicles with vehicle level senders
– Release and pull off connector -1- on rear left vehicle level
sender - G76- .
– Detach wire -2- from clip -arrow-.
Continuation for all vehicles
– Detach brake line -1- from clip -arrow- on mounting bracket
(right-side).
Note
The clip will be destroyed and must be renewed.
– Remove the coil springs
– Use tensioning straps - T10038- to strap vehicle to support
beams of lifting platform on both sides.
WARNING
If the vehicle is not strapped down, it may slip off the lifting
platform.
150
Rep. gr.42 - Rear suspension
⇒ page 215 .