León 2013 ➤ , León ST 2013 ➤
Running gear, axles, steering - Edition 06.2018
– Lower wheel bearing housing -1- in direction of -arrow- using
engine and gearbox jack - VAS 6931- .
– Press wheel bearing housing upwards using engine and gear‐
box jack - VAS 6931- thus nearing the suspension strut.
– Bolt swivel joint to suspension link again and continue to press
wheel bearing housing upwards until final position is reached
on suspension strut.
– Remove the splitter - 3424-
– Insert new bolts, tip of bolt must point in direction of travel.
– Attach wheel bearing housing to suspension strut using new
nut -arrow-.
Installation is carried out in reverse order, noting the following:
Note
The lever of the vehicle level sender must point towards the
♦
outside of the vehicle.
Thread of vehicle level sender must be screwed into outer hole
♦
in suspension link. Retaining lug for vehicle level sender must
engage in inner hole in order to guarantee correct installation
position.
64
Rep. gr.40 - Front suspension