– Use felt-tip pen or similar to mark position of eccentric bolt
-2- in relation to subframe.
– Unscrew the nut -1- and extract the bolt -2-.
– Take out lower transverse link.
Installing
Installation is carried out in reverse order, noting the following:
– On vehicles with vehicle level sender, carry out basic setting
⇒ Vehicle diagnostic tester.
•
Observe mark made for position of eccentric bolt -2- relative
to subframe.
•
The threaded connections of the transverse link may only be
loosened and tightened in the unladen weight position
⇒ page 8
.
•
On vehicles with vehicle level sender, carry out basic setting
⇒ Vehicle diagnostic tester.
•
On vehicles with vehicle level sender, carry out basic adjust‐
ment of headlights ⇒ Electrical system; Rep. gr. 94 ; Head‐
lights; Adjusting headlights .
– Check wheel alignment
Specified torques
♦
⇒ "5.1 Assembly overview - transverse links", page 195
♦
⇒ "2.2.2 Assembly overview - rear vehicle level senders, multi-
link suspension, front-wheel drive", page 283
♦ Rear exhaust system ⇒ Rep. gr. 26 ; Exhaust pipes/silencers;
Assembly overview - silencer .
5.5
Removing and installing coupling rod
(for anti-roll bar)
Special tools and workshop equipment required
♦ Torque wrench - V.A.G 1331-
⇒ page 302
.
León 2013 ➤ , León ST 2013 ➤
Running gear, axles, steering - Edition 06.2018
5. Suspension link, track rod
203