Removing And Installing Coupling Rod (For Anti-Roll Bar) - Seat Leon 2013 Workshop Manual

– Tighten the new clamp -1- using locking pliers for Phaeton
steering rack - VAS 6199- .
– Tighten clamp so that its ear -arrow- is positioned as shown in
illustration.
– Screw in track rod ball joint up to mark made during removal
and install ⇒ page 384
– Mount the front wheel and screw tight.
– Align wheels of vehicle
– If both track rods have been exchanged, basic setting must be
carried out for steering angle sender - G85- ⇒ Vehicle diag‐
nostic tester.
– Then carry out basic setting of steering ⇒ Vehicle diagnostic
tester.
Specified torques
♦ ⇒ "3.1 Assembly overview - steering box", page 358
♦ ⇒ "3.6 Repairing steering box", page 385
3.4

Removing and installing coupling rod (for anti-roll bar)

Special tools and workshop
equipment required
.
⇒ page 299 .
León 2013 ➤ , León ST 2013 ➤
Running gear, axles, steering - Edition 06.2018
381
3. Steering rack