Renewing Bonded Rubber Bush For Lower Suspension Link - Seat Leon 2013 Workshop Manual

León 2013 ➤ , León ST 2013 ➤
Running gear, axles, steering - Edition 06.2018
– Tighten nuts -arrows-.
Note
The lever of the vehicle level sender must point towards the
♦
outside of the vehicle.
Thread of vehicle level sender must be screwed into outer hole
♦
in suspension link. Retaining lug for vehicle level sender must
engage in inner hole in order to guarantee correct installation
position.
– Install wheel and tighten.
– Tighten drive shaft bolt at wheel hub
Note
During this step, vehicle must not be standing on its wheels or
wheel bearing will be damaged.
– On vehicles with vehicle level sender, carry out basic setting
⇒ Vehicle diagnostic tester.
Specified torques
♦ ⇒ "4.1 Assembly overview - lower suspension link, swivel
joint", page 68
♦ ⇒ "2.1 Assembly overview - front vehicle level sender",
page 281
♦ ⇒ "6.2 Assembly overview - drive shaft", page 98
4.5 Renewing bonded rubber bush for lower
suspension link
⇒ "4.5.1 Renewing front bonded rubber bush for lower suspension
link", page 80
⇒ "4.5.2 Renewing rear bonded rubber bush for lower suspension
link", page 83
4.5.1 Renewing front bonded rubber bush for lower suspension link
80
Rep. gr.40 - Front suspension
⇒ page 120 .