Seat Leon 2013 Workshop Manual page 140

León 2013 ➤ , León ST 2013 ➤
Running gear, axles, steering - Edition 06.2018
♦ Puller - T10382-
Removing the dustguard for exterior constant velocity joint
– Clamp drive shaft in vice using protective jaw covers.
– Push the dust guard backwards.
– Set puller - T10382- up so that smooth side of puller plate -
T10382/1- points to spindle - T10382/2- .
– Assemble puller - T10382- complete with multi-purpose tool -
VW 771- .
– Pull constant velocity joint from drive shaft with puller -
T10382- and multi-purpose tool - VW 771- .
1 - Holding plate - T10382/1-
2 - Spindles - T10382/2-
Driving on outer constant velocity joint
– Install new retaining ring.
– If necessary, push new joint boot onto drive shaft.
– Knock onto shaft with plastic hammer until circlip engages.
Dismantling triple roller joint
– Clamp drive shaft in vice using protective jaw covers.
– Open both clip on inner joint and push back boot.
– Pull joint body off drive shaft.
– Remove circlip.
1 - Pliers (commercially available)
- or -VW 161 A-
– Set drive shaft into press.
134
Rep. gr.40 - Front suspension