Seat Leon 2013 Workshop Manual page 125

– It is essential to follow specified sequence.
I - Tighten knurled nut -1- hand-tight.
II - Turn only bolt -2- using a spanner in order to press out drive
shaft with press tool - T10520- .
Note
At the end of the procedure or for pressing out drive shaft further
the spindle must be moved to its original position in order to de‐
ploy the hydraulic force!
Installing
Installation is carried out in reverse order, noting the following:
Note
Remove any paint residues and/or corrosion on thread and
splines of outer joint.
– Fit the drive shaft.
– Guide outer joint into wheel hub splines as far as possible.
León 2013 ➤ , León ST 2013 ➤
Running gear, axles, steering - Edition 06.2018
119
6. Drive shaft