Seat Leon 2013 Workshop Manual page 249

– Carefully push wheel hub/wheel bearing unit -2- onto stub
axle.
Caution
Ensure that the wheel hubs/wheel bearing unit does not cant!
– Screw in new bolt -1- and tighten to specified torque.
Note
First tighten bolt to specified torque setting using torque
♦
wrench.
Use a rigid spanner for turning further by angle.
♦
Caution
Do not use an impact driver when tightening bolt -1- with socket
- T10162 A- -2-!
– Drive in dust cap.
1 - Fitting sleeve - 3241/4-
Always renew removed grease caps.
Damaged grease caps may allow moisture to enter the bearing.
Therefore, always use the tool shown in the illustration.
Specified torques
♦ ⇒ "7.1.2 Assembly overview - suspension, multi-link suspen‐
sion, front-wheel drive", page 225
♦ Bolts for heat shield, brake caliper and brake disc ⇒ Brake
system; Rep. gr. 46 ; Rear brakes; Assembly overview - rear
brakes
7.4.3 Removing and installing wheel bearing
unit, multi-link suspension, four-wheel
drive
Special tools and workshop equipment required
León 2013 ➤ , León ST 2013 ➤
Running gear, axles, steering - Edition 06.2018
7. Wheel bearing, trailing arm
243