León 2013 ➤ , León ST 2013 ➤
Running gear, axles, steering - Edition 06.2018
Using press tool - T10520- :
– To be able to press out the drive shaft -3-, secure press tool -
T10520- -1- to the wheel hub -2- using 3 wheel bolts.
– It is essential to follow specified sequence.
I - Tighten knurled nut -1- hand-tight.
II - Turn only bolt -2- using a spanner in order to press out drive
shaft with press tool - T10520- .
Note
At the end of the procedure or for pressing out drive shaft further
the spindle must be moved to its original position in order to de‐
ploy the hydraulic force!
– Secure drive shaft to body with wire.
Caution
Do not let the drive shaft hang down under its own weight, as
otherwise excessive bending could damage the inner CV joint.
Vehicles with adaptive chassis control DCC
– Disconnect connector -1- on shock absorber -2-.
Note
If there is moisture in the area of the connector, blow compressed
air on the contacts on the shock absorber and the connector.
60
Rep. gr.40 - Front suspension