Seat Leon 2013 Workshop Manual page 366

León 2013 ➤ , León ST 2013 ➤
Running gear, axles, steering - Edition 06.2018
11 - Fastener
12 -
3.1.2 Assembly overview - steering box, right-
hand drive
Assembly overview - steering rack, track rods
Caution
The following work must not be performed while the universal
joint is separated from the electromechanical steering rack:
♦ Connect battery.
♦ Switch on ignition.
♦ Turning the steering rack
♦ Turning the steering column
Not adhering to these instructions will result in irreparable
damage.
1 - Wire
2 - Heat shield
❑ Different versions possi‐
ble depending on en‐
gine version. Refer to ⇒
Electronic parts cata‐
logue "ETKA"
3 - Bolt
❑ Either 3x or 4x are fitted
depending on engine
version. Refer to ⇒
Electronic parts cata‐
logue "ETKA"
❑ 8 Nm
4 - Seal
❑ Renew after removing
steering rack
5 - Steering rack
❑ Removing and installing
⇒ page 362
❑ Assembly overview
⇒ page 361
❑ Different versions possi‐
ble. Refer to ⇒ Electron‐
ic parts catalogue "ET‐
KA"
❑ With power steering
control unit - J500-
❑ Can be checked using
⇒ Vehicle diagnostic
tester in "Guided fault
finding" mode.
360
Rep. gr.48 - Steering
⇒ page 361