Removing And Installing Wheel Bearing Unit - Seat Leon 2013 Workshop Manual

– Tighten the bolts -2- and -3-.
• On vehicles with vehicle level sender, carry out basic setting
⇒ Vehicle diagnostic tester.
• On vehicles with vehicle level sender, carry out basic adjust‐
ment of headlights ⇒ Electrical system; Rep. gr. 94 ; Head‐
lights; Adjusting headlights .
Specified torques
♦ ⇒ "7.1.3 Assembly overview - suspension, multi-link suspen‐
sion, four-wheel drive", page 226
♦ ⇒ "6.1.2 Assembly overview - suspension strut, shock absorb‐
er, spring, multi-link suspension", page 206
♦ ⇒ "7.2 Assembly overview - trailing arm", page 227
♦ ⇒ "5.2 Assembly overview - track rod", page 198
♦ ⇒ "2.2.2 Assembly overview - rear vehicle level senders, multi-
link suspension, front-wheel drive", page 283
♦ ⇒ "8.4 Loosening and tightening threaded connections of drive
shaft", page 266
♦ Bolts for heat shield, brake caliper and brake disc ⇒ Brake
system; Rep. gr. 46 ; Rear brakes; Assembly overview - rear
brakes
7.4 Removing and installing wheel bearing
unit
⇒ "7.4.1 Removing and installing wheel bearing unit, torsion beam
axle", page 237
⇒ "7.4.2 Removing and installing wheel bearing unit, multi-link
suspension, front-wheel drive", page 240
⇒ "7.4.3 Removing and installing wheel bearing unit, multi-link
suspension, four-wheel drive", page 243
7.4.1 Removing and installing wheel bearing unit, torsion beam axle
León 2013 ➤ , León ST 2013 ➤
Running gear, axles, steering - Edition 06.2018
7. Wheel bearing, trailing arm
237