León 2013 ➤ , León ST 2013 ➤
Running gear, axles, steering - Edition 06.2018
– Remove bolt -arrow-.
Tighten outer bolt on drive shaft.
– Renew outer bolt for drive shaft.
Note
It must be ensured that the wheels do not yet touch the floor when
the drive shaft is being tightened. Otherwise the wheel bearing
may be damaged.
– Have second mechanic apply brakes.
– Tighten bolt to 200 Nm.
– Lower vehicle onto its wheels.
– Turn bolt 180° further.
6.5
Removing and installing drive shaft heat
shield
FWD:
Component
Screws -1-
Four-wheel drive:
Component
Nuts -1-
6.6
Dismantling and assembling drive shaft
⇒ "6.6.1 Dismantling and assembling drive shaft, constant veloc‐
ity joint VL100", page 122
⇒ "6.6.2 Dismantling and assembling drive shaft, constant veloc‐
ity joint VL107", page 127
⇒ "6.6.3 Dismantling and assembling drive shaft, triple roller joint
AAR3300i", page 132
6.6.1
Dismantling and assembling drive shaft, constant velocity joint VL100
122
Rep. gr.40 - Front suspension
Specified torque
25 Nm
Specified torque
20 Nm