Seat Leon 2013 Workshop Manual page 172

León 2013 ➤ , León ST 2013 ➤
Running gear, axles, steering - Edition 06.2018
– Before pressing in bonded rubber bush, make sure that mark‐
ing on bush is in line with marking on axle beam.
– Press bonded rubber bush in to stop.
– Check the position of the bonded metal-rubber bush once fit‐
ted.
Installation is carried out in reverse order, noting the following:
• On vehicles with vehicle level sender, carry out basic setting
⇒ Vehicle diagnostic tester.
• On vehicles with vehicle level sender, carry out basic adjust‐
ment of headlights ⇒ Electrical system; Rep. gr. 94 ; Head‐
lights; Adjusting headlights .
Specified torques
♦ ⇒ "2.1 Assembly overview - axle beam", page 159
♦ ⇒ "2.2.1 Assembly overview - rear vehicle level sender, torsion
beam axle", page 282
166
Rep. gr.42 - Rear suspension