Seat Leon 2013 Workshop Manual page 162

León 2013 ➤ , León ST 2013 ➤
Running gear, axles, steering - Edition 06.2018
– First pull handbrake cable -1- off locking lugs, then pull com‐
pletely out of bracket -2-.
– Detach electrical wiring harness from retainers -arrows- and
move clear.
Vehicles with vehicle level senders
– Unplug the electrical connector -1-.
– Unscrew bolt -2-.
– Remove rear left vehicle level sender - G76- -3- from trans‐
verse link.
Continuation for all vehicles
– Remove the coil springs
– Pull out retaining clip -1- on both sides of vehicle.
– Move brake line clear of retainer.
Note
Do not open brake line.
– Detach propshaft from rear final drive and secure ⇒ Propshaft
and rear final drive; Rep. gr. 39 ; Propshaft; Assembly over‐
view - propshaft .
– Remove right and left brake calipers and fasten to body with
brake lines connected ⇒ Brake system; Rep. gr. 46 ; Rear
brake; Assembly overview - rear brake .
– Remove rear silencer of exhaust system ⇒ Rep. gr. 26 ; Ex‐
haust pipes/silencers; Assembly overview - silencers .
– Use tensioning straps - T10038- to strap vehicle to support
beams of lifting platform on both sides.
WARNING
If the vehicle is not strapped down, it may slip off the lifting
platform.
– Locate subframe in position
– Unclip electrical wire -2- on mounting bracket -1- and move
clear.
– Mark installation position of mounting bracket -1- on body.
156
Rep. gr.42 - Rear suspension
⇒ page 215 .
⇒ page 169 .