Seat Leon 2013 Workshop Manual page 77

Tighten bolts -arrows-. Counterhold at rear bolt on nut at top while
doing so.
Note
Use new bolts and nut!
♦
Tighten nuts and bolts -arrows- in unladen state
♦
Perform further installation in reverse order, paying attention to
the following:
Note
The lever of the vehicle level sender must point towards the
♦
outside of the vehicle.
Thread of vehicle level sender must be screwed into outer hole
♦
in suspension link. Retaining lug for vehicle level sender must
engage in inner hole in order to guarantee correct installation
position.
– On vehicles with vehicle level sender, carry out basic setting
⇒ Vehicle diagnostic tester.
Specified torques
♦ ⇒ "4.1 Assembly overview - lower suspension link, swivel
joint", page 68
♦ ⇒ "2.1 Assembly overview - front vehicle level sender",
page 281
♦ Bolts for noise insulation ⇒ General body repairs, exterior;
Rep. gr. 66 ; Noise insulation; Assembly overview - noise in‐
sulation .
4.2.2 Removing and installing lower suspen‐
sion link, vehicles with dual clutch gear‐
box DSG 0D9
Special tools and workshop equipment required
♦ Torque wrench - V.A.G 1332-
León 2013 ➤ , León ST 2013 ➤
Running gear, axles, steering - Edition 06.2018
⇒ page 5 .
4. Lower suspension link, swivel joint
71