Seat Leon 2013 Workshop Manual page 260

León 2013 ➤ , León ST 2013 ➤
Running gear, axles, steering - Edition 06.2018
Pressing out bonded rubber bush
– Position tools as shown in figure.
1 - Press tool - VW 412-
2 - Tube -3346/1- from assembly tool - 3346- (the deep recess
must face the bonded rubber bush)
3 - Trailing arm
4 - Bonded rubber bush
5 - Tube for wheel bearing - 3345-
6 - Tightening plate - VW 402-
– Press out bonded rubber bush.
Insert the bonded rubber bush
– Mark position of bonded rubber bush on trailing arm using a
set square.
– Position outer edge of set square on upper radius of hole -1-
and on lower radius of hole -2-.
– Make a mark above and below the trailing arm bush respec‐
tively -arrows-.
a - 90°
Position bonded rubber bush on trailing arm so that marked line
-arrows- lies between the raised portions -1-.
Note
Take great care to ensure that the installation position of the bon‐
ded rubber bush is correct relative to the bush in the trailing arm.
254
Rep. gr.42 - Rear suspension