Seat Leon 2013 Workshop Manual page 120

León 2013 ➤ , León ST 2013 ➤
Running gear, axles, steering - Edition 06.2018
– Unscrew nuts -arrows-.
– Pull wheel bearing housing with swivel joint out of suspension
link.
– Remove the drive shaft from the wheel hub and fasten to the
bodywork.
If the drive shaft cannot be pulled out of the wheel bearing by
hand, use press tool - T10520- .
Before using the press tool - T10520- ensure that the thrust piece
-1- is inserted.
Using press tool - T10520- :
– To be able to press out the drive shaft -3-, secure press tool -
T10520- -1- to the wheel hub -2- using 3 wheel bolts.
– It is essential to follow specified sequence.
I - Tighten knurled nut -1- hand-tight.
II - Turn only bolt -2- using a spanner in order to press out drive
shaft with press tool - T10520- .
Note
At the end of the procedure or for pressing out drive shaft further
the spindle must be moved to its original position in order to de‐
ploy the hydraulic force!
114
Rep. gr.40 - Front suspension