Removing And Installing Drive Shaft - Seat Leon 2013 Workshop Manual

❑ Insert in groove in shaft
9 - Dustguard for constant velocity joint
❑ Material: Hytrel (polyester elastomer)
❑ Without breather hole
❑ Check for splits and chafing
❑ Drive off constant velocity joint with a drift
❑ Coat sealing surface of constant velocity joint with -D 454 300 A2- before installing.
10 - Clamp
❑ Always renew after removing
❑ Tightening ⇒ page 266
11 - Locking plate
12 - Multi-point socket head bolt
❑ Always renew after removing
❑ Initially tighten diagonally to 10 Nm and then tighten diagonally to specified torque.
❑ 40 Nm
13 - Cover
❑ Always renew after removing
❑ Always renew
❑ Pressing off ⇒ page 264
14 - Retaining ring
❑ Always renew after removing
❑ Remove and install with circlip pliers - VW 161 A-
15 - Seal
❑ Always renew after removing
❑ The surface that is attached to the constant velocity joint should be free of grease and oil
16 - Inner constant velocity joint
❑ Always replace completely
❑ Distribute grease filling evenly in joint
❑ Pressing off ⇒ page 265
❑ Insertion ⇒ page 265
❑ Checking ⇒ page 269
17 - Dished spring
❑ With internal groove
❑ Installation position
8.2

Removing and installing drive shaft

Special tools and workshop equipment required
⇒ page 265
León 2013 ➤ , León ST 2013 ➤
Running gear, axles, steering - Edition 06.2018
257
8. Drive shaft