Seat Leon 2013 Workshop Manual page 191

– Pull out retaining clip -1- on both sides of vehicle.
Note
Do not open brake line.
– Use tensioning straps - T10038- to strap vehicle to support
beams of lifting platform on both sides.
WARNING
If the vehicle is not strapped down, it may slip off the lifting
platform.
– Locate subframe in position
– Mark installation position of bonded rubber bush in relation to
subframe with e.g. a felt-tip pen -1-.
Note
Make a mark -1- on subframe centred on cut-out in bonded rubber
bush -2-.
– Lever anti-twist device -1- off bonded rubber bush near re‐
taining lug using, for example, a screwdriver -2-.
– Lower subframe approx. 100 mm using engine and gearbox
jack - VAS 6931- .
Running gear, axles, steering - Edition 06.2018
⇒ page 169 .
León 2013 ➤ , León ST 2013 ➤
185
3. Subframe