Seat Leon 2013 Workshop Manual page 270

León 2013 ➤ , León ST 2013 ➤
Running gear, axles, steering - Edition 06.2018
Dismantling
Driving out constant velocity joint
– Clamp drive shaft in vice using protective jaw covers.
– Remove clamps.
– Push the dust guard backwards.
– Remove the constant velocity joint from the drive shaft using
an awl -A-.
Drift must be positioned exactly on ball hub of constant velocity
joint.
Position the seal
Installation position of dished spring at outer joint
1 - Dished spring
– Fit new circlip.
– Use plastic-headed hammer to drive joint onto shaft until circlip
engages.
Separate cover for inner constant velocity joint
264
Rep. gr.42 - Rear suspension