Seat Leon 2013 Workshop Manual page 136

León 2013 ➤ , León ST 2013 ➤
Running gear, axles, steering - Edition 06.2018
– Pull constant velocity joint from drive shaft with puller -
T10382- and multi-purpose tool - VW 771- .
1 - Holding plate - T10382/1-
2 - Spindles - T10382/2-
Driving on outer constant velocity joint
– Install new retaining ring.
– If necessary, push new joint boot onto drive shaft.
– Knock onto shaft with plastic hammer until circlip engages.
Separate cover for inner constant velocity joint
– Remove circlip.
– Remove both clamps and slide boot towards outer joint.
– Separate the dustguard with a punch.
Pressing off inner constant velocity joint
Assembling
Pressing on inner constant velocity joint
– Press joint on to stop.
– Install retaining ring.
130
Rep. gr.40 - Front suspension