Seat Leon 2013 Workshop Manual page 215

– Unscrew bolt -1-.
– Remove shock absorber.
Installing
Install in reverse order of removal. During this step, observe the
following:
– On vehicles with vehicle level sender, carry out basic setting
⇒ Vehicle diagnostic tester.
Specified torques
♦ ⇒ "6.1.1 Assembly overview - suspension strut, shock absorb‐
er, spring, torsion beam axle", page 205
♦ Wheel housing liner ⇒ General body repairs, exterior; Rep.
gr. 66 ; Wheel housing liner; Removing and installing rear
wheel housing liner .
6.2.2 Removing and installing shock absorbers, multi-link suspension
Special tools and workshop
equipment required
♦ Torque wrench - V.A.G 1332-
♦ Torque wrench - V.A.G 1410-
♦ Spring tensor - V.A.G 1752/1-
León 2013 ➤ , León ST 2013 ➤
Running gear, axles, steering - Edition 06.2018
6. Suspension strut, shock absorber, spring
209