Seat Leon 2013 Workshop Manual page 160

León 2013 ➤ , León ST 2013 ➤
Running gear, axles, steering - Edition 06.2018
– Unclip electrical wire -2- on mounting bracket -1- and move
clear.
– Mark installation position of mounting bracket -1- on body.
– Remove bolts -arrows-.
– Carefully lower subframe with attachments by maximum of
30 mm.
– Unclip brake line from clips -arrows-.
Note
The clips will be destroyed and must be renewed.
♦
For reasons of clarity, the illustration shows the subframe from
♦
above in removed state.
♦ The number of clips may vary.
– Lower subframe with attached components.
Note
When lowering, ensure sufficient clearance to brake lines and
electrical wiring.
Installing subframe with attachments
Installation is carried out in reverse order, noting the following:
• On vehicles with vehicle level sender, carry out basic setting
⇒ Vehicle diagnostic tester.
• On vehicles with vehicle level sender, carry out basic adjust‐
ment of headlights ⇒ Electrical system; Rep. gr. 94 ; Head‐
lights; Adjusting headlights .
Specified torques
♦ ⇒ "3 Subframe", page 167
♦ ⇒ "7.2 Assembly overview - trailing arm", page 227
♦ ⇒ "6.1.2 Assembly overview - suspension strut, shock absorb‐
er, spring, multi-link suspension", page 206
♦ ⇒ "2.2.2 Assembly overview - rear vehicle level senders, multi-
link suspension, front-wheel drive", page 283
♦ Bolts for brake caliper and brake disc ⇒ Brake system; Rep.
gr. 46 ; Rear brakes; Assembly overview - rear brakes
♦ Exhaust pipes double clamp ⇒ Rep. gr. 26 ; Exhaust pipes/
silencers; Assembly overview - silencer .
– When does wheel alignment have to be checked
⇒ page 302 ?
154
Rep. gr.42 - Rear suspension