Seat Leon 2013 Workshop Manual page 210

León 2013 ➤ , León ST 2013 ➤
Running gear, axles, steering - Edition 06.2018
♦ Torque wrench - V.A.G 1332-
Removing
– Loosen wheel bolts.
– Raise vehicle.
– Remove wheel.
– Remove bolts -arrows- for anti-roll bar -1-.
– Unscrew nut -1- and bolt -3- by a few turns.
– Unscrew bolt -3-.
– Unscrew nut -1- and remove bolt -4- towards rear. At the same
time, push the stabiliser upwards.
– Take out track rod -2-.
Installing
Installation is carried out in reverse order, noting the following:
• Before tightening bolt securing track rod, obtain the same dis‐
tance between wheel hub centre and lower edge of wheel
housing as measured before dismantling
– Check wheel alignment
Specified torques
♦ ⇒ "5.2 Assembly overview - track rod", page 198
♦ ⇒ "4.1 Assembly overview - anti-roll bar", page 190
204
Rep. gr.42 - Rear suspension
⇒ page 8
⇒ page 302 .
.