Seat Leon 2013 Workshop Manual page 363

♦ Socket - T10424-
Removing
– Remove steering column switch module ⇒ Electrical system;
Rep. gr. 94 ; Steering column switch module; Removing and
installing steering column switch module .
– Separate the connector -2-. For this purpose, slide the un‐
locking element -1- to rear and press down the release catch.
– Unscrew shear bolt -3- using socket - T10424- .
– Remove the control unit for electronic steering column lock -
J764- -item 4-.
Note
If it is not possible to remove the shear bolt with the special socket
spanner - T10424- , you must drill using an angle drill and a ∅
8.5 mm drill bit.
Installing
Installation is carried out in reverse order, noting the following:
– Tighten new bolts -arrows- until shear heads break off.
– Install steering column switch module ⇒ Electrical system;
Rep. gr. 94 ; Steering column switch module; Removing and
installing steering column switch module .
– Perform steps to initiate ⇒ Vehicle diagnostic tester.
León 2013 ➤ , León ST 2013 ➤
Running gear, axles, steering - Edition 06.2018
357
2. Steering column