Seat Leon 2013 Workshop Manual page 350

León 2013 ➤ , León ST 2013 ➤
Running gear, axles, steering - Edition 06.2018
– Unscrew bolt -1-.
– Check that steering column has a centre punch mark that
aligns with mark on steering wheel.
– If this is not the case, the position of the steering wheel to
steering column must be marked on the steering column with
a centre punch mark.
– Pull steering wheel -2- off steering column.
Installing
Installation is carried out in reverse order, noting the following:
Make sure that the wheels are pointing straight ahead before fit‐
ting the steering wheel.
– When installing a steering wheel that has been removed,
make sure that the markings on the steering column and steer‐
ing wheel are in line.
– When installing a new steering wheel (without marking), the
steering wheel must be mounted in middle position (steering
wheel spoke must be horizontal and wheels in straight posi‐
tion).
– Fitting the steering wheel
– Install airbag unit ⇒ General body repairs, interior; Rep. gr.
69 ; Airbag (driver side); Assembly overview - airbag (driver
side)
– Take vehicle for a test drive.
– If the steering wheel is skewed, the steering wheel must be
removed again and fitted onto the splines of the steering col‐
umn.
Specified torques
♦ ⇒ "1.1 Assembly overview - steering wheel", page 342
344
Rep. gr.48 - Steering