Seat Leon 2013 Workshop Manual page 79

– Detach exhaust system bracket from subframe -arrows-.
– Press the engine support - T10533- fully together to as short
a length as possible.
– Screw the engine support - T10533- -2- under large angle
-arrow- onto the gearbox. To do this, use the short screws of
the pendulum support screw connection -1-.
– Press the drive module forwards until the threaded rod -
T10533/5- -3- can be inserted into the pendulum support
bearing.
– Pull apart the engine support - T10533- , until the distance
-a- between the screw of the axle guide -1- and the gearbox
meets.
a = 85 mm
Note
If there is not enough space between gearbox and fan shroud,
remove fan shroud ⇒ Rep. gr. 19 ; Radiator/radiator fan; Re‐
moving and installing fan shroud .
– Unscrew bolts -arrows-. Counterhold at rear bolt on nut at top
while doing so.
León 2013 ➤ , León ST 2013 ➤
Running gear, axles, steering - Edition 06.2018
4. Lower suspension link, swivel joint
73