Seat Leon 2013 Workshop Manual page 83

Special tools and workshop equipment required
♦ Puller - T10520-
Removing
– Loosen drive shaft bolt at wheel hub
Caution
Wheel bearings must not be subjected to load after loosening
bolt securing drive shaft at wheel hub.
If they have to support the weight of the vehicle they will be
damages and their service life will be reduced.
It is not permissible to turn drive shaft bolt more than 90° anti-
clockwise if vehicle is standing on its wheels.
Do not attempt to move the vehicle without the drive shafts
fitted; this would result in wheel bearing damage. If it is nec‐
essary for a vehicle to be moved, please comply with the
following instructions:
♦ Install an outer joint instead of the drive shaft.
♦ Tighten outer joint to 120 Nm.
– Loosen wheel bolts.
– Raise vehicle.
– Remove wheel.
Vehicles with vehicle level senders
– Remove nut -1-.
– Pull bracket -2- for front left vehicle level sender - G78- and/or
for front right vehicle level sender - G289- out of suspension
link -3-, as applicable
Running gear, axles, steering - Edition 06.2018
⇒ page 120 .
León 2013 ➤ , León ST 2013 ➤
4. Lower suspension link, swivel joint
77