Seat Leon 2013 Workshop Manual page 187

6 - Hydraulic press - VAS 6178- and thrust piece - T10205/13-
7 - Hexagonal nut - T10263/5-
8 - Threaded spindle - T10263/4-
– Take up play in special tools.
– Press out bonded rubber bush.
Note
The shoulder of the outer ring of the bonded rubber bush is sheared off by the mounting when the bush is
♦
pulled out. This occurs with a loud bang.
The bonded rubber bush must be removed from the tube - T10356/2- with light hammer blows once the
♦
bush has been pulled out.
Pressing in front bonded rubber bush
– As an assembly aid, draw a line -1- vertically on the shoulder
of the bonded rubber bush.
– Coat outer edge of bonded rubber bush with assembly paste
-G 294 421 A1-.
– Set up special tools with bonded rubber bush on subframe as
shown.
León 2013 ➤ , León ST 2013 ➤
Running gear, axles, steering - Edition 06.2018
181
3. Subframe