Seat Leon 2013 Workshop Manual page 394

León 2013 ➤ , León ST 2013 ➤
Running gear, axles, steering - Edition 06.2018
– Drive out threaded bush -1- in -direction of arrow-.
Installing
Installation is carried out in reverse order, noting the following:
Note
Always drive in threaded bush from above and from direction of
the steering shaft.
– Insert threaded bush in a straight line.
– Drive in threaded bush as far as stop.
– Position steering rack -1- on subframe.
– Threaded sleeves -2- of steering rack must be inserted in
holes in subframe -arrow-.
– On vehicles with vehicle level sender, carry out basic setting
⇒ Vehicle diagnostic tester.
Specified torques
♦ ⇒ "2.1 Assembly overview - subframe", page 18
♦ ⇒ "3.1 Assembly overview - steering box", page 358
♦ Bolts for pendulum support ⇒ Rep. gr. 10 ; Assembly mount‐
ings; Assembly overview - assembly mountings .
♦ Bolts for noise insulation ⇒ General body repairs, exterior;
Rep. gr. 66 ; Noise insulation; Assembly overview - noise in‐
sulation .
♦ Exhaust system to subframe ⇒ Rep. gr. 26 ; Exhaust pipes/
silencers; Assembly overview - silencer .
If even when using locating pins - T10486/1- a crooked steering
wheel is determined during the road test, carry out a wheel align‐
ment check. In this case the wheel alignment test results must be
archived in the vehicle files.
388
Rep. gr.48 - Steering