Removing And Installing Rear Vehicle Level Senders G76 / G77 - Seat Leon 2013 Workshop Manual

León 2013 ➤ , León ST 2013 ➤
Running gear, axles, steering - Edition 06.2018
– Unscrew bolt -1-.
– Remove front left vehicle level sender - G78- and/or front right
vehicle level sender - G289- , as applicable.
Installing
Installation is carried out in reverse order, noting the following:
Note
The lever of the vehicle level sender must point towards the
♦
outside of the vehicle.
Thread of vehicle level sender must be screwed into outer hole
♦
in suspension link. Retaining lug for vehicle level sender must
engage in inner hole in order to guarantee correct installation
position.
• Perform basic setting ⇒ Vehicle diagnostic tester.
• If the reference position has been re-adapted, the front camera
for driver assist systems must be recalibrated on vehicles with
lane departure warning function
⇒ "4.1 Calibrating front camera for driver assist systems", page
335 .
• Perform basic setting of headlights ⇒ Electrical system; Rep.
gr. 94 ; Headlights; Adjusting headlights .
Specified torques
♦ ⇒ "2.1 Assembly overview - front vehicle level sender",
page 281
2.4 Removing and installing rear vehicle
level senders -G76- / -G77-
⇒ "2.4.1 Removing and installing rear left vehicle level sender
G76 , torsion beam axle", page 286
⇒ "2.4.2 Removing and installing rear left vehicle level sender
G76 , multi-link suspension, front-wheel drive", page 287
⇒ "2.4.3 Removing and installing rear left vehicle level sender
G76 , multi-link suspension, four-wheel drive", page 288
2.4.1 Removing and installing rear left vehicle
level sender - G76- , torsion beam axle
Special tools and workshop equipment required
♦ Torque wrench - V.A.G 1410-
286
Rep. gr.43 - Self-levelling suspension