León 2013 ➤ , León ST 2013 ➤
Running gear, axles, steering - Edition 06.2018
– Unscrew bolt -1-.
– Take out wheel bearing housing -6-.
Installing
Installation is carried out in reverse order, noting the following:
It is essential to follow specified sequence of work steps below!
– Insert wheel bearing housing -2-.
– Insert bolt -1- and tighten only hand-tight.
– Start bolt -3-.
– Insert washer -2-.
– Screw in bolt -1-, and tighten it by hand.
– Position engine and gearbox jack - VAS 6931- -1- under track
rod and press upwards slightly.
– Screw in bolts -2- and -3- hand-tight.
– Remove engine and gearbox jack - VAS 6931- -1- under the
track rod.
– Install heat shield ⇒ Brake system; Rep. gr. 46 ; Rear brakes;
Assembly overview - rear brakes .
– Install wheel bearing unit
The threaded connections of the wheel bearing housing may only
be loosened and tightened in the unladen weight position
⇒ page 5
.
230
Rep. gr.42 - Rear suspension
⇒ page 237
.