Removing And Installing Coupling Rod - Seat Leon 2013 Workshop Manual

León 2013 ➤ , León ST 2013 ➤
Running gear, axles, steering - Edition 06.2018
– Tighten nuts -arrows-.
– On vehicles with vehicle level sender, carry out basic settings
for wheel damper electronics ⇒ Vehicle diagnostic tester
Specified torques
♦ ⇒ "2.1 Assembly overview - subframe", page 18
♦ ⇒ "2.1 Assembly overview - steering column", page 345
♦ ⇒ "2.1 Assembly overview - front vehicle level sender",
page 281
♦ Bolts for pendulum support ⇒ Rep. gr. 10 ; Assembly mount‐
ings; Assembly overview - assembly mountings
♦ Bolts for noise insulation ⇒ General body repairs, exterior;
Rep. gr. 66 ; Noise insulation; Assembly overview - noise in‐
sulation .
♦ Exhaust pipes double clamp ⇒ Rep. gr. 26 ; Exhaust pipes/
silencers; Assembly overview - silencer .
If even when using locating pins - T10486/1- a crooked steering
wheel is determined during the road test, carry out a wheel align‐
ment check. In this case the wheel alignment test results must be
archived in the vehicle files.
2.6

Removing and installing coupling rod

Special tools and workshop equipment required
♦ Torque wrench - V.A.G 1332-
Removing
– Unscrew nut -arrow- and pull coupling rod -1- out from sus‐
pension strut.
46
Rep. gr.40 - Front suspension