Removing And Installing Lower Suspension Link - Seat Leon 2013 Workshop Manual

11 - Subframe
4.2 Removing and installing lower suspen‐
sion link
⇒ "4.2.1 Removing and installing lower suspension link, vehicle
with manual gearbox or dual clutch gearbox 0CW", page 69
⇒ "4.2.2 Removing and installing lower suspension link, vehicles
with dual clutch gearbox DSG 0D9", page 71
4.2.1 Removing and installing lower suspen‐
sion link, vehicle with manual gearbox or
dual clutch gearbox 0CW
Special tools and workshop equipment required
♦ Torque wrench - V.A.G 1332-
Removing
– Loosen wheel bolts.
– Raise vehicle.
– Remove wheel.
– If fitted, remove noise insulation ⇒ General body repairs, ex‐
terior; Rep. gr. 66 ; Noise insulation; Assembly overview -
noise insulation .
– Release rear area of wheel housing liner and fold it forwards.
Vehicles with vehicle level senders
– Remove nut -1-.
– Pull bracket -2- for front left vehicle level sender - G78- and/or
for front right vehicle level sender - G289- out of suspension
link -3-, as applicable
León 2013 ➤ , León ST 2013 ➤
Running gear, axles, steering - Edition 06.2018
4. Lower suspension link, swivel joint
69