Seat Leon 2013 Workshop Manual page 157

Engine and gearbox jack - VAS 6931-
– Unclip electrical wiring -2- at mounting bracket -1- and axle
beam and move clear.
– Mark positions of bolts -arrows- on mounting bracket -1- on left
and right sides of vehicle and remove them.
– Slightly take up weight of rear axle using the engine and gear‐
box jack - VAS 6931- -1-.
– Unbolt rear axle from shock absorbers -arrows-.
– Lower rear axle with the engine and gearbox jack - VAS 6931-
-1-.
1 - Engine and gearbox jack - VAS 6931-
2 - Universal gearbox support - V.A.G 1359/2- (only for engine
and gearbox jack - VAS 6931- )
Installing
Installation is carried out in reverse order, noting the following:
• On vehicles with vehicle level sender, carry out basic setting
⇒ Vehicle diagnostic tester.
• On vehicles with vehicle level sender, carry out basic adjust‐
ment of headlights ⇒ Electrical system; Rep. gr. 94 ; Head‐
lights; Adjusting headlights .
• Tighten bolted connection securing shock absorber to axle
beam with suspension in unladen position
Specified torques
♦ ⇒ "2.1 Assembly overview - axle beam", page 159
♦ ⇒ "6.1.1 Assembly overview - suspension strut, shock absorb‐
er, spring, torsion beam axle", page 205
♦ Bolts for brake caliper and brake disc ⇒ Brake system; Rep.
gr. 46 ; Rear brakes; Assembly overview - rear brakes
1.3.2 Removing and installing rear axle, multi-
link suspension, front-wheel drive
Special tools and workshop equipment required
León 2013 ➤ , León ST 2013 ➤
Running gear, axles, steering - Edition 06.2018
⇒ page 8 .
151
1. Rear axle