– Install exhaust system bracket on the subframe -arrows-.
Perform further installation in reverse order, paying attention to
the following:
Note
The lever of the vehicle level sender must point towards the
♦
outside of the vehicle.
Thread of vehicle level sender must be screwed into outer hole
♦
in suspension link. Retaining lug for vehicle level sender must
engage in inner hole in order to guarantee correct installation
position.
– On vehicles with vehicle level sender, carry out basic setting
⇒ Vehicle diagnostic tester.
Specified torques
♦
⇒ "4.1 Assembly overview - lower suspension link, swivel
joint", page 68
♦
⇒ "2.1 Assembly overview - front vehicle level sender",
page 281
♦ Bolts for pendulum support ⇒ Rep. gr. 10 ; Assembly mount‐
ings; Assembly overview - assembly mountings
♦ Bolts for noise insulation ⇒ General body repairs, exterior;
Rep. gr. 66 ; Noise insulation; Assembly overview - noise in‐
sulation .
♦ Exhaust pipes double clamp ⇒ Rep. gr. 26 ; Exhaust pipes/
silencers; Assembly overview - silencer .
♦ Exhaust system to subframe ⇒ Rep. gr. 26 ; Exhaust pipes/
silencers; Assembly overview - silencer .
♦ Propshaft ⇒ Rep. gr. 39 ; Propshaft; Assembly overview -
propshaft .
4.3
Checking swivel joint
checking axial clearance
– Firmly pull suspension link down in -direction of arrow- and
press up again.
León 2013 ➤ , León ST 2013 ➤
Running gear, axles, steering - Edition 06.2018
4. Lower suspension link, swivel joint
75