Seat Leon 2013 Workshop Manual page 241

– Insert wheel bearing housing -2-.
– Insert bolt -1- and tighten only hand-tight.
– Insert bolt -4- with washer -3-.
– Insert washer -2-.
– Screw in bolt -1-, and tighten it by hand.
– Position engine and gearbox jack - VAS 6931- -1- under track
rod and press upwards slightly.
– Screw in bolts -2- and -3- hand-tight.
– Remove engine and gearbox jack - VAS 6931- -1- under the
track rod.
– Install wheel bearing unit
– Install heat shield ⇒ Brake system; Rep. gr. 46 ; Rear brakes;
Assembly overview - rear brakes .
Bolt wheel bearing housing to body only in unladen position
⇒ page 8
– Tighten nut -1-.
⇒ page 237 .
León 2013 ➤ , León ST 2013 ➤
Running gear, axles, steering - Edition 06.2018
7. Wheel bearing, trailing arm
235