Removing And Installing Wheel Bearing Unit - Seat Leon 2013 Workshop Manual

– Tighten nuts -arrows-.
Note
The lever of the vehicle level sender must point towards the
♦
outside of the vehicle.
Thread of vehicle level sender must be screwed into outer hole
♦
in suspension link. Retaining lug for vehicle level sender must
engage in inner hole in order to guarantee correct installation
position.
– On vehicles with vehicle level sender, carry out basic setting
⇒ Vehicle diagnostic tester.
Specified torques
♦ ⇒ "5.1 Assembly overview - wheel bearing", page 87
♦ ⇒ "4.1 Assembly overview - lower suspension link, swivel
joint", page 68
♦ ⇒ "3.1 Assembly overview - suspension strut, upper suspen‐
sion link", page 56
♦ ⇒ "6.2 Assembly overview - drive shaft", page 98
♦ ⇒ "2.1 Assembly overview - front vehicle level sender",
page 281
♦ Screw for speed sender ⇒ Brake system; Rep. gr. 45 ; Sen‐
sors; Assembly overview - Front axle speed sender
♦ Bolts for splash plate, brake caliper, brake disc ⇒ Brake sys‐
tem; Rep. gr. 46 ; Front brakes; Assembly overview - front
brakes
5.3 Removing and installing wheel bearing
unit
Special tools and workshop equipment required
♦ Torque wrench - V.A.G 1332-
Removing
– Remove bolt for drive shaft
Running gear, axles, steering - Edition 06.2018
⇒ page 120 .
León 2013 ➤ , León ST 2013 ➤
5. Wheel bearing
93