Seat Leon 2013 Workshop Manual page 68

León 2013 ➤ , León ST 2013 ➤
Running gear, axles, steering - Edition 06.2018
– Lower wheel bearing housing -1- in direction of -arrow- using
engine and gearbox jack - VAS 6931- .
– Lower wheel bearing housing -1- until shock absorber is hang‐
ing free -arrow-.
– Bolt swivel joint to suspension link again and tighten wheel
bearing housing to subframe.
– Remove the engine and gearbox jack - VAS 6931- from under
support - T10149- .
WARNING
♦ Do not leave the hydraulic jack - VAS 6931- underneath
the vehicle longer than necessary.
– Pull seal off entire length of plenum chamber cover.
– Unclip the filler piece.
– Unhook the clips -2-.
– Lift plenum chamber cover -1- not more than 60 mm.
a - 60 mm
– Unscrew bolts -1- for upper shock absorber mounting and take
out suspension strut.
Installing
– Position suspension strut so that the arrow -1- is always on the
inner side.
– One of the two arrows -1- on the spring plate -2- must point in
direction of travel.
62
Rep. gr.40 - Front suspension