Seat Leon 2013 Workshop Manual page 285

♦ Torque wrench - V.A.G 1410-
Removing
– Pull seal off entire length of plenum chamber cover.
– Unclip the filler piece.
– Unhook the clips -2-.
– Lift plenum chamber cover -1- not more than 60 mm.
a - 60 mm
– Release electrical connector -1- and pull off.
– Unscrew bolt -2-.
– Remove front body acceleration sender .
Installing
Installation is carried out in reverse order, noting the following:
– Insert front body acceleration sender -1- so that connector
-arrow- points to rear (opposite to normal direction of travel).
– Tighten bolt -2- for front body acceleration sender -1-.
Installation position: angle tolerance -a- is ±10°. Installation po‐
sition of front body acceleration sender may deviate by this angle
along the longitudinal axis of the vehicle.
– Perform basic setting of wheel damper electronics ⇒ Vehicle
diagnostic tester.
Specified torques
Component
Front body acceleration sender
to body
Running gear, axles, steering - Edition 06.2018
Specified torque
8 Nm
León 2013 ➤ , León ST 2013 ➤
1. Electronically controlled damping system
279