Seat Leon 2013 Workshop Manual page 13

Before raising wheel unit, secure vehicle to arms of lifting platform
using tensioning straps - T10038- .
WARNING
If the vehicle is not strapped down, there is a danger that the
vehicle will slip off the lifting platform/hoist.
– Turn wheel hub until one of the wheel bolt holes is at the top.
– Attach support - T10149- to wheel hub using wheel bolt.
Respective nuts and bolts may be tightened only when dimension
-a- between the centre of wheel hub and edge of wheel housing
has been attained.
Note
This measurement must be taken with the suspension in the un‐
laden position (vehicle unladen).
The dimension -a- depends on the ride height of the installed run‐
ning gear:
Front running gear
1)
Standard running gear
Running gear for sports model
Running gear for poor roads
Running gear for poor roads
Cupra running gear with DCC
Cupra running gear without
DCC
Cupra R chassis with DCC
1) The running gear fitted to the vehicle is specified in the vehicle data sheet. The
running gear is identified by the PR number. The PR number assigned to the
⇒ page 309
running gear is found here
– Raise wheel bearing housing using engine and gearbox jack
- VAS 6931- until dimension -a- is attained.
WARNING
♦ Do not raise or lower the vehicle while the engine and
gearbox jack is positioned under the vehicle.
♦ Do not leave the hydraulic jack - VAS 6931- underneath
the vehicle longer than necessary.
– Tighten respective nuts and bolts.
– Lower wheel bearing housing.
– Pull engine and gearbox jack - VAS 6931- out from under ve‐
hicle.
– Remove support - T10149- .
Running gear, axles, steering - Edition 06.2018
Height of bodywork -a- in mm
384 mm
369 mm
399 mm
384 mm
359 mm
369 mm
359 mm
.
León 2013 ➤ , León ST 2013 ➤
2. Repair instructions
7