Removing And Installing Coupling Rod - Seat Leon 2013 Workshop Manual

León 2013 ➤ , León ST 2013 ➤
Running gear, axles, steering - Edition 06.2018
Note
The following steps are described for the left side of the vehicle.
The procedure for the right side of the vehicle is identical.
– Remove the coil springs
– Remove bolts -arrows- for anti-roll bar -1-.
– Unscrew nut -1- securing coupling rod -2-.
– Pull coupling rod -2- out of anti-roll bar -3-.
– Remove anti-roll bar -3- from subframe.
Vehicles with all-wheel drive
– Guide out anti-roll bar over exhaust system.
Installing
Installation is carried out in reverse order, noting the following:
– Tighten bolts -arrows- for anti-roll bar -1- evenly on subframe
-2-.
Specified torques
♦ ⇒ "4.1 Assembly overview - anti-roll bar", page 190
4.3

Removing and installing coupling rod

192
Rep. gr.42 - Rear suspension
⇒ page 215 .