Seat Leon 2013 Workshop Manual page 88

León 2013 ➤ , León ST 2013 ➤
Running gear, axles, steering - Edition 06.2018
Pressing out bonded rubber bush
– Press out bonded rubber bush as shown.
1 - Press tool - VW 411-
2 - Tube - T10219/1- (the cut-out must face the suspension link)
3 - Tightening plate - VW 402-
Insert the bonded rubber bush
– Align bonded rubber bushes -1- to suspension link -2-.
The grooves -3- must face towards suspension link -2- as shown
in illustration.
– Apply assembly lubricant - G 294 421 A1- to outside of bonded
rubber bush.
– Press in bonded rubber bush as illustrated.
1 - Drift - T10219/2-
2 - Bonded rubber bush
3 - Tube - T10219/1- (the cut-out must face the suspension link)
4 - Tightening plate - VW 402-
Note
At start of pressing-in process, bonded rubber bush is temporarily
slanted. During further procedure, the bonded rubber bush then
straightens. It does not have to be pushed further.
– Press in bonded rubber bush until core of bush -1- and hole in
suspension link -2- are flush.
82
Rep. gr.40 - Front suspension