Seat Leon 2013 Workshop Manual page 141

– Press triple roller star off drive shaft.
– Pull boot off shaft.
– Clean shaft, joint body and groove for seal.
Assembling triple roller joint
– Push small hose clip for bellows onto shaft.
– Push joint boot onto shaft.
Fitting triple roller star
Chamfer on triple roller star -arrow- faces towards shaft and
serves as an assembly aid.
– Fit triple roller spider on shaft and press on as far as stop.
– Ensure that pressure does not exceed 3.0 t.
– If necessary, coat splines of drive shafts and triple roller star
with lubricating paste - G 052 142 A2- .
– Insert retaining ring, ensuring that it is seated correctly.
– Press half of total amount of grease from repair kit into triple
roller joint.
– Place boot adapter onto joint.
– Slide joint body over rollers and hold.
– Press remaining amount of grease from repair kit into rear of
triple roller joint.
– Slide boot onto boot adapter and ensure that boot engages
correctly in groove -arrow- of adapter.
León 2013 ➤ , León ST 2013 ➤
Running gear, axles, steering - Edition 06.2018
135
6. Drive shaft