– Remove nut -1- from coupling rod -3-.
– Pull coupling rod -3- out of anti-roll bar -2-.
Installing
Installation is carried out in reverse order, noting the following:
•
Tighten the nuts holding the coupling rod on the suspension
strut and the stabiliser. If necessary with end-piece through
internal serration.
Specified torques
♦
⇒ "2.1 Assembly overview - subframe", page 18
2.7
Repairing thread in longitudinal member
Repairing the thread in captive nuts in the longitudinal member is
possible only under certain conditions ⇒ Body Repairs; Rep. gr.
50 .
2.8
Fixing position of subframe
Note
Certain repairs on vehicles require the removal of the sub‐
♦
frame or the entire front axle.
The original position of the subframe relative to the body can
♦
be retained with the aid of qty. 4 locating pins - T10486/1- .
Qty. 2 locating pins - T10486/1- are a part of locating device -
♦
T10486- . If the assembly tool - T10486- is already available
in the workshop, only the supplementary set consisting of 2x
locating pins - T10486/1- will then be required.
If the assembly tool - T10486- is not available in the workshop,
♦
then the assembly tool - T10486 A- can be used. The contains
4x locating pins - T10486/1- and 2x locating pins - T10486/2- .
The locating pins - T10486/2- are not required for the following
procedure.
Special tools and workshop equipment required
♦ 4 Locating pins - T10486/1-
León 2013 ➤ , León ST 2013 ➤
Running gear, axles, steering - Edition 06.2018
47
2. Subframe