Seat Leon 2013 Workshop Manual page 254

León 2013 ➤ , León ST 2013 ➤
Running gear, axles, steering - Edition 06.2018
Note
When pulling in, make sure that the tip of the spindle - 3301/1-
♦
does not stick to the wheel bearing housing.
Do not use lubricant.
♦
Insert bearing carefully so it does not cant.
♦
1 - Nut from assembly tool - 3301-
2 - Thrust plate from assembly tool - 3301-
3 - Thrust piece from assembly tool - 3346- , with open side
facing towards wheel bearing housing
4 - Wheel bearing housing
5 - Bonded rubber bush
6 - Thrust piece - 3367/2-
7 - Spindle - 3301/1-
– Pull in bonded rubber bush just far enough that it is positioned
right in front of wheel bearing housing by turning nut - 3301-
-1-. When doing this, counterhold spindle - 3301/1- -7-.
– Remove tools, and fit them again as shown in illustration.
1 - Nut from assembly tool - 3301-
2 - Thrust plate from assembly tool - 3301-
3 - Thrust piece from assembly tool - 3346- , with open side
facing towards wheel bearing housing
4 - Wheel bearing housing
5 - Thrust piece - 3367/2-
6 - Thrust piece - 3301/2-
7 - Spindle - 3301/1-
– Pull in bonded rubber bush to stop by turning nut - 3301- -1-.
When doing this, counterhold spindle - 3301/1- -7-.
Installing
The remaining installation steps are carried out in reverse se‐
quence - note the following points:
• On vehicles with vehicle level sender, carry out basic setting
⇒ Vehicle diagnostic tester.
• On vehicles with vehicle level sender, carry out basic adjust‐
ment of headlights ⇒ Electrical system; Rep. gr. 94 ; Head‐
lights; Adjusting headlights .
• The threaded connections to the lower transverse link may
only be loosened and tightened in the unladen weight position
⇒ page 5 .
Specified torques
♦ ⇒ "7.1 Assembly overview - wheel bearing", page 223
♦ ⇒ "6.1.2 Assembly overview - suspension strut, shock absorb‐
er, spring, multi-link suspension", page 206
♦ ⇒ "4.1.1 Assembly overview - anti-roll bar, multi-link suspen‐
sion, front-wheel drive", page 190
248
Rep. gr.42 - Rear suspension