Seat Leon 2013 Workshop Manual page 113

– Tighten nuts -arrows-.
Note
Lever on vehicle level sender must face towards outside of
♦
vehicle.
Thread of vehicle level sender must be screwed into outer hole
♦
in suspension link. Retaining lug for vehicle level sender must
engage in inner hole in order to guarantee correct installation
position.
– On vehicles with vehicle level sender, carry out basic setting
⇒ Vehicle diagnostic tester.
• On vehicles with vehicle level sender, carry out basic adjust‐
ment of headlights ⇒ Electrical system; Rep. gr. 94 ; Head‐
lights; Adjusting headlights .
Specified torques
♦ ⇒ "6.2 Assembly overview - drive shaft", page 98
♦ ⇒ "6.4 Loosening and tightening threaded connections of drive
shaft", page 120
♦ ⇒ "2.1 Assembly overview - subframe", page 18
♦ ⇒ "2.1 Assembly overview - front vehicle level sender",
page 281
♦ ⇒ "4.1 Assembly overview - lower suspension link, swivel
joint", page 68
♦ Bolts for noise insulation ⇒ General body repairs, exterior;
Rep. gr. 66 ; Noise insulation; Assembly overview - noise in‐
sulation .
6.3.2 Removing and installing drive shaft,
right drive shaft, constant velocity joints
VL100 and VL107
Special tools and workshop equipment required
♦ Torque wrench - V.A.G 1332-
León 2013 ➤ , León ST 2013 ➤
Running gear, axles, steering - Edition 06.2018
107
6. Drive shaft